Diagnose Your Car's Problem

By using the DriverSide Diagnostic Tool, you agree to the Terms of Use.

Or, Ask the DriverSide Mechanics.

Enter a Question:
Which Car is This Question About?

Recent Questions

Rattle sound on passenger side when at low revs
I have a slight rattle in my 320i on the passenger side when pulling away at low revs. The rattle sounds more like a vibration which can be heard in the cabin. This ceases after in...
Asked by Karl R September 2, 2014, 8:51 am 2 replies
how do i fix this
My dash is dead and it keeps sayin no bus ...what's wrong
Asked by James C September 2, 2014, 6:52 am 1 reply
how do i fix my stereo?
The stereo lights up, keeps time, changes stations, and everything else its supposed to do but no sound comes from the speakers. The air conditioning did leak at one point but is f...
Asked by Cloe H September 1, 2014, 9:19 pm 1 reply
2007 Infiniti M35x running hot?
Was driving and air cut off and the car started idling up and temperature gauge went to hot. I pulled over to check fluid, and the radiator fluid seems to be full in radiator, but ...
Asked by Shavon W September 1, 2014, 6:53 pm 1 reply
What is couasing my rear brakes to grind?
I changed my rear rotors and brake pads and now I have a loud grinding noise coming form the rear tires. It grinds as the wheel accelerates not as I brake. I made sure the dust cov...
Asked by Tyler L September 1, 2014, 2:11 pm 1 reply
What do I do when my car bangs into 1st gear hard.
When starting from stationary position and I step on the gas it bangs into 1st gear hard. If I go real slow sometimes I can avoid that. Is there anything that I can use to lesse...
Asked by Michael L September 1, 2014, 12:10 pm 1 reply
Hyundai Sonata front caliper sticking, non ABS
So a couple days ago out of the blue, my front left brake starts sticking, pulled over off the interstate, jacked up the car and took the tire off. The caliper was locked up pretty...
Asked by Derek T August 31, 2014, 8:56 am 2 replies
timing belt on 97 Ford Ranger 2.3L
I replaced the timing belt on my 97 ranger 2.3L engine and aligned the marks on the camshaft pulley and oil pump pulley to the plastic marks on the rear timing belt cover, AND i al...
Asked by Kevin K September 1, 2014, 10:05 am 1 reply
1 2 3 4 5