Need Help?

1993 Chevrolet C K 1500 Base Reg Cab 117.5 WB

1993 Chevrolet C K 1500
Do you own this car?
Estimated Mileage
 Miles
Enter current mileage for most
accurate info about this vehicle


Track Your Service Records
Get Recall Alerts
Get Updated Value Estimates on Your Car.

Ask the Community

Ask Our Auto Mechanics

Ask our panel of certified mechanics a question. We pay for their advice so you don't have to.

Enter a Question:
Details:
Which Car is This Question About?

Recent Questions

charge rate for dianosing and replacing a bad distributer
a guy tows in his truck not running and ask me to try to fix it. I diagnosed it and found the distributer bad and replaced it. the truck runs great. how much should I charge for my...
Asked by Keith W July 7, 2014, 3:13 pm 1 reply
when I hold the wires bundled under vortec box up it runs as soon as I let go it dies?
Everything ignition wise has been changed
Asked by Corey B July 13, 2014, 2:42 am 0 reply
What are possible problems?
Sounds like it about to start but doesn't. Changed ignition coil, new battery, no spark thru spark plug wires
Asked by Appollis S June 30, 2014, 12:36 pm 1 reply
if a knocksensor is bad,how will it affect engine performance?
98 Chevy 1500 4.3 v-6 vortech. start,s right up & dies
Asked by Charles D June 22, 2014, 8:39 pm 1 reply
How to replace distributor?
I tried using my chiltons manual to replace my distributor because the cap was being help down by a zip tie instead of screws because the original screws broke off in the screw hol...
Asked by Taylor W June 21, 2014, 6:19 pm 1 reply
why nothing in my fuels system will get power?
Fuel pump and relay and fuses are all good and engine light won't come on when ignition us turned on
Asked by Dustin B July 3, 2014, 12:30 pm 0 reply
WHERE IS THE SLVE CYLINDER LOCATED ON MY 1997 CHEVY 1500 WITH A 4.3 V6
DO I NEED TO DROP THE TRANS
Asked by MATTHEW W July 2, 2014, 11:23 am 0 reply
i changed pcm on my98 4-3 and it runs bad. what do i do next?
I put p.m. from a chevy suburban on my 98 1500 4'3 v-6 and it runs rough. what needs to be done next?
Asked by Charles D June 21, 2014, 8:00 pm 1 reply
Speedometer calibration
I changed the rear end out from a 3.73 to 3.42. I need to calibrate the speedometer to match the new configuration. No one seems to know how. Any suggestions?
Asked by Jason F June 20, 2014, 11:30 am 0 reply
Brakes spongy after new master cylinder and new booster
I have put $450 into my truck. I have replaced my rear wheel cylinder, front calipers, front pads, and finally a new master cylinder and a new brake booster (unloaded). After all m...
Asked by Joe S June 3, 2014, 1:05 pm 0 reply
1 2 3 4 5 




My Auto Score

See the free AutoCheck score

Meet The Experts
Kim Perrin
Kim Perrin is our resident mechanic here at DriverSide. Kim worked as…
Tyler Orr
Tyler Orr is an expert in German and Japanese cars and has been a mechanic …
Elizabeth Kriesten
Elizabeth Kriesten worked as an automotive technician for several years at Dodge…
Tips on Servicing

Car Brakes: How Do You Know When to Change Them?

By Zach Bowman For those who suffer a daily commute through heavy traffic, your vehicle's braking system can bring thousands of pounds of metal, plastic and empty Starbucks cups to a stop hundreds of times before you get to work. It goes without saying that these pieces wear out, but they do so slowly, meaning you may not notice they need attention until ...

Read more…