Need Help?

1996 Chevrolet S-10 Base Reg Cab 108.3 WB

1996 Chevrolet S-10
Trim Info:
Rear Wheel Drive, Reg Cab 6' Fleetside
23 mpg city / 30 mpg hwy
Other Trims
Do you own this car?
Estimated Mileage
 Miles
Enter current mileage for most
accurate info about this vehicle


Track Your Service Records
Get Recall Alerts
Get Updated Value Estimates on Your Car.

Ask the Community

Ask Our Auto Mechanics

Ask our panel of certified mechanics a question. We pay for their advice so you don't have to.

Enter a Question:
Details:
Which Car is This Question About?

Recent Questions

S10 wont start
1995 s10 Chevy 4.3 vortec fuel is 65 psi.replaced coil,icm,crank sensor,distributor,cap and rotor.still will not start.
Asked by Tom M January 28, 2015, 1:32 pm 0 reply
All my truck wants to do is rev up when it gets past 40-45 mph.
I went up a hill last night and it reved up real bad and i got back to flat ground and it drives fine till i get to about 40-45 mph and it wants to rev up real bad.
Asked by William B January 26, 2015, 5:24 am 0 reply
Truck wont start
Truck will turn over but wont start, have gas in it but it acts like it's not getting gas!
Asked by Harry H January 25, 2015, 10:40 am 0 reply
96 Chevy s 10 4.3l has poor fuel mileage. throws po300 codes like 5 times a day.
Replaced plugs and wires. No change, back fires on deceleration. Surges at a steady speed so must always be accelerating. Scanner shows timing fluctuates between-18 to-40. Has 200k...
Asked by Jason H January 10, 2015, 12:33 pm 5 replies
Chevy S10 replace ignition tumbler. Car dies immed. Security light flashes...
Thank you for any help.
Asked by Jim F January 24, 2015, 2:30 pm 0 reply
low power on take off -torque convertor?
has a 1 year old motor and always runs good. suddenly is laboring from a standing start but, runs an accelerates fine at travel speeds. could this be a bad torque convertor
Asked by Ken T January 21, 2015, 5:52 am 1 reply
2002 Chevy S10 SES light on.....code C0000.
My SES is on, and the only code that shows up is C0000. Truck runs fine. Shifts fine, speedometer works fine. What could be the issue???? Just want this light to go out already.
Asked by Mike G January 20, 2015, 9:26 am 0 reply
I am having trouble removing the upper ball joint(front left side). Any ideas?
2 wheel drive 6 cylinder I am down to the back plate. The lower ball joint is off but the upper wont budge. I removed the cotter pin and the crown nut but it wont release from the ...
Asked by William M January 19, 2015, 6:22 pm 0 reply
what do i do when the key is broken off in the ignition and the steering wheel is locked ?
it wont let me take out the ignition lock
Asked by John J January 18, 2015, 1:28 am 1 reply
starter bolt snapped and is in the block.
if it is a 3/8 x 4 1/4 bolt : with thread diameter 7/16 NC what drill bit size do I use to re-thread and use 7/16 hell coil ?
Asked by Kuni F January 17, 2015, 12:43 pm 1 reply
1 2 3 4 5 




My Auto Score

See the free AutoCheck score

Meet The Experts
Kim Perrin
Kim Perrin is our resident mechanic here at DriverSide. Kim worked as…
Tyler Orr
Tyler Orr is an expert in German and Japanese cars and has been a mechanic …
Elizabeth Kriesten
Elizabeth Kriesten worked as an automotive technician for several years at Dodge…
Tips on Servicing

Car Brakes: How Do You Know When to Change Them?

By Zach Bowman For those who suffer a daily commute through heavy traffic, your vehicle's braking system can bring thousands of pounds of metal, plastic and empty Starbucks cups to a stop hundreds of times before you get to work. It goes without saying that these pieces wear out, but they do so slowly, meaning you may not notice they need attention until ...

Read more…