Need Help?

2011 Ford F-150 XLT 2WD Reg Cab 126

2011 Ford F-150
Trim Info:
Rear Wheel Drive, Reg Cab 6.5' Styleside
17 (est) mpg city / 23 (est) mpg hwy
Other Trims
Do you own this car?
Estimated Mileage
Enter current mileage for most
accurate info about this vehicle

Track Your Service Records
Get Recall Alerts
Get Updated Value Estimates on Your Car.
Ask the Community

Ask Our Auto Mechanics

Ask our panel of certified mechanics a question. We pay for their advice so you don't have to.

Enter a Question:
Which Car is This Question About?

Recent Questions

I have the 302 5.0 what would be the best way to go about turbo charging it
Found one to order do i need to doanything in advance to run a turbo
Asked by Chris C March 3, 2015, 10:19 pm 0 reply
What is causing check engine code P0446
I have replaced my EVAP valve & canister solenoid and erased the code 4x it still is coding out.
Asked by Joshua W February 27, 2015, 10:05 am 2 replies
rough rotors
Hello Dear Mechanics, I had my rotors and brake pads replaced. The garage put alternative rotors on. they are not used ones, as it was told to me. I brought car back because i use ...
Asked by Inge P February 25, 2015, 7:21 pm 2 replies
Idle falls and rises
My 2009 Ford F-150 fx4 while idling the idle will fall below 500 rpms then rise again continuously. What's the problem?
Asked by Clay R February 27, 2015, 2:09 pm 1 reply
wipers not working
I replace the wiper motor and switch. The fuse is not burn out. So I figure it the relay to the motor. Where is the Relay located.
Asked by Jefferson H February 24, 2015, 8:22 am 1 reply
I have a 92 4.9 inline 6 4x4 f150 clutch master cylinder won't bleed
I just replaced clutch, and slave cylinder, and now it's not bleeding. I worked with it for 2.5 hours, but pedal still has no tension on it. should I try to keep pumping pedal, or ...
Asked by Wesley H February 22, 2015, 7:22 pm 0 reply
Can I install a Steering Stabilizer on my truck without it being lifted?
I have slightly oversized tires. I have recently gotten an alignment, new ball joints and an idler arm. As well as the wheels balanced and am still getting a decent bounce at highw...
Asked by Michael W February 19, 2015, 11:35 am 1 reply
my truck keeps dieing
It starts great but when u lift ur foot off the pedal it starts to die anytime u stop at a light or slow down to turn
Asked by Brandon H February 15, 2015, 2:22 pm 1 reply
There was a grinding noise coming from my front end and I change bearrings but the noise still the
Any ideas on if it's the cv axel needs to be changed at the same time will the noise stop
Asked by Sid S February 15, 2015, 7:24 pm 1 reply
can you turn the fly wheel by hand with the starter still mounted?
i changed the front seal in tranny,put the tranny back in,and mounted the starter,and now i can't turn the fly wheel to mount the torque converter bolts.
Asked by Roy S February 16, 2015, 4:57 am 1 reply

My Auto Score

See the free AutoCheck score

Meet The Experts
Kim Perrin
Kim Perrin is our resident mechanic here at DriverSide. Kim worked as…
Tyler Orr
Tyler Orr is an expert in German and Japanese cars and has been a mechanic …
Elizabeth Kriesten
Elizabeth Kriesten worked as an automotive technician for several years at Dodge…
Tips on Servicing

Car Brakes: How Do You Know When to Change Them?

By Zach Bowman For those who suffer a daily commute through heavy traffic, your vehicle's braking system can bring thousands of pounds of metal, plastic and empty Starbucks cups to a stop hundreds of times before you get to work. It goes without saying that these pieces wear out, but they do so slowly, meaning you may not notice they need attention until ...

Read more…