Need Help?

1992 GMC Sierra 2500 Base Reg Cab 131.5 WB

1992 GMC Sierra 2500
Do you own this car?
Estimated Mileage
 Miles
Enter current mileage for most
accurate info about this vehicle


Track Your Service Records
Get Recall Alerts
Get Updated Value Estimates on Your Car.

Ask the Community

Ask Our Auto Mechanics

Ask our panel of certified mechanics a question. We pay for their advice so you don't have to.

Enter a Question:
Details:
Which Car is This Question About?

Recent Questions

Valve noise at higher RPMs
350 TBI motor, 17x,xxx miles. Doesn't use much oil, running 5w30 dino. Starts normally, no problems at continued lower (under 2k) RPMs. On freeway after anywhere from 20-45 minu...
Asked by Rob B April 25, 2014, 7:30 am 1 reply
how do bleed the line to the slave cylinder
I have a gmc 2500 94...i changed the slave cylinder and cant get any presser back to tje clutch... i need to know how to bleed it and how long it takes
Asked by Casey B February 23, 2014, 11:27 am 0 reply
Engine chocks down and sputters when you punch down on the gas
Replaced fuel pump and fuel filter. Acts like its not getting gas
Asked by Rhonda W January 26, 2014, 5:54 pm 0 reply
truck not running properly if at all
I have a 97 gmc sierra k2500 with a 5.7 vortec..my issue is it started with a loss of power, then getting harder n harder to start until one day it didnt anymore.. iv changed fuel ...
Asked by KJ S January 10, 2014, 11:55 pm 0 reply
four wheel drive problem
front drive shaft does not spin with load against front tires. changed four wheel drive friction and steel plates, new actuator, and new encoder motor. works fine with no load. no...
Asked by Les W December 27, 2013, 7:25 am 0 reply
what causes grinding noise when I put my truck in 4x4?
Truck is a 1993 GMC sierra 6.5 td. I usually have to wait 10 secs for the 4x4 to engage but I tried putting it in 4x4 and the light came on instantly. Tried to pull forward and it ...
Asked by Francis N December 5, 2013, 9:57 am 1 reply
power steering/ brakes noise
when starting vehicle everything is normal. 1- while in park pressing brakes it makes a grinding sound. 2-while in park steering makes grinding sound. 3-steering turns hard, power ...
Asked by Victor B October 4, 2013, 10:21 am 1 reply
I would like to put a mild Turbo in 1993 2500 GMC Sierra (5.7). Installing it isn't the problem, but
I'm not going to do this if I have to send off my computer to be re-tuned...
Asked by James P May 30, 2012, 1:17 pm 1 reply
Starter making clicking noise
Brand new starter still just clicking not engauging the flywheel
Asked by Brandon M January 27, 2012, 6:27 pm 1 reply
No power to trailer
I have factory installed trailer harness. I changed 3 fuse's,does the harness have any relays? Are their any fusible links? When I hookup to trailer only the rear light on driver'...
Asked by George.C. W December 15, 2011, 3:38 pm 1 reply
1 2 




My Auto Score

See the free AutoCheck score

Meet The Experts
Kim Perrin
Kim Perrin is our resident mechanic here at DriverSide. Kim worked as…
Tyler Orr
Tyler Orr is an expert in German and Japanese cars and has been a mechanic …
Elizabeth Kriesten
Elizabeth Kriesten worked as an automotive technician for several years at Dodge…
Tips on Servicing

Car Brakes: How Do You Know When to Change Them?

By Zach Bowman For those who suffer a daily commute through heavy traffic, your vehicle's braking system can bring thousands of pounds of metal, plastic and empty Starbucks cups to a stop hundreds of times before you get to work. It goes without saying that these pieces wear out, but they do so slowly, meaning you may not notice they need attention until ...

Read more…