Need Help?

1979 Jeep J10 20 Pickup 4WD Base

1979 Jeep J10 20 Pickup 4WD
Do you own this car?
Estimated Mileage
 Miles
Enter current mileage for most
accurate info about this vehicle


Track Your Service Records
Get Recall Alerts
Get Updated Value Estimates on Your Car.

Ask the Community

Ask Our Auto Mechanics

Ask our panel of certified mechanics a question. We pay for their advice so you don't have to.

Enter a Question:
Details:
Which Car is This Question About?

Recent Questions

I need to replace my in the column ignition key. How do I get to it?
I took off the steering wheel and there is a metal plate with holes and notches in it. Under that is the turn signal, How do you bet the place off?
Asked by Paul J July 16, 2013, 5:02 pm 0 reply
how to take off the steering wheel
The steering wheel has not been removed in about 30 years or so, what is the best procedure to remove it when a puller is not working and pk blaster did not work either
Asked by Julie A August 5, 2012, 3:03 pm 1 reply
What 5 speed trans will work in a 1977 jeep j10 with a 258 straight six 4x4
What 5 speed trans will work in a 1977 jeep j10 with a 258 straight six 4x4
Asked by Sam B February 26, 2010, 1:47 pm 2 replies
how much would it cost me to restore this car?
it apears to be mostly cosmetic damage. the grill is missing, the headlights don't work, the tires are flat, the coler was blue but it faded and rusted a bit. on the inside, the se...
Asked by Theodore H January 30, 2010, 7:37 pm 1 reply
j 20 jeep p/u steering wheel stays in place but jeep wanders first one way then the other
replaced steering damper , other visible parts seem ok [tie rods etc.] one owner 219 m kilometres
Asked by Alexmccoll  January 22, 2010, 1:32 pm 1 reply
changing out ignition key module on nsteering column
There is a slotted plate that became visible once the steering wheel was removed, how do I remove the slotted plate to access the ignition key module?
Asked by JOHN S July 16, 2009, 12:34 pm 1 reply
Changing Ignition Key Module on Steering Column
Changing ignition key module on steering column, pulled steering wheel and there is a slotted plate behind steering wheel how do I remove plate to access ignition key module?
Asked by JOHN S July 16, 2009, 12:32 pm 1 reply
my jeep is clicking when in 4x4 ween i gas on it.
my jeep is clicking when in 4x4 ween i gas on it.
Asked by Dwayne C May 7, 2009, 8:10 pm 1 reply
my jeep truck is very hard to start in the morning. i have
my jeep truck is very hard to start in the morning. i have adjusted the choke it make very little difrence. could it be the points or the dist.timing or bad pluges. it runs a littl...
Asked by Lennie P November 30, 2008, 3:24 pm 1 reply



My Auto Score

See the free AutoCheck score

Meet The Experts
Kim Perrin
Kim Perrin is our resident mechanic here at DriverSide. Kim worked as…
Tyler Orr
Tyler Orr is an expert in German and Japanese cars and has been a mechanic …
Elizabeth Kriesten
Elizabeth Kriesten worked as an automotive technician for several years at Dodge…
Tips on Servicing

Car Brakes: How Do You Know When to Change Them?

By Zach Bowman For those who suffer a daily commute through heavy traffic, your vehicle's braking system can bring thousands of pounds of metal, plastic and empty Starbucks cups to a stop hundreds of times before you get to work. It goes without saying that these pieces wear out, but they do so slowly, meaning you may not notice they need attention until ...

Read more…